2015 Kia Soul Serpentine Belt Diagram (2024)

FAQs

How do you find a serpentine belt routing diagram? ›

Where can I find a belt routing diagram for my engine? A: Commonly a belt routing diagram sticker is on the underside of the hood or in the engine compartment. If there is no diagram, make a sketch of the belt and pulleys before removing the belt. This will help you re-route the new belt correctly.

Your engine is not equipped with a timing belt.

The average cost for a Kia Soul Serpentine Belt Replacement is between $69 and $96.

Replacing the serpentine belt is as simple as threading it into position, cranking the tensioner and slipping the belt over the tensioner pulley, or nearest pulley up top. Belt tensioners are mostly spring tension. Once installed, the spring retains pressure to the belt.

As an example, “8PK2515” is the PK number found on an OEM serpentine belt. The first digit indicates an eight-rib belt, followed by “P” to identify metric belt sizing, and a “K” showing that this belt conforms to the SAE standard for rib sizing (3.56 millimeters wide for automotive-type serpentine belts).

Are Serpentine Belts Directional? Because nearly all serpentine belts are symmetrical, a new belt's direction of rotation usually doesn't matter. What does matter, though, is that the new belt is routed correctly around the pulleys. It's also important that the grooved side of the belt faces toward the pulley grooves.

If you do notice your belt needs replacing, you can do it yourself if you're mechanically minded and have the time. It'll take about 1 or 2 hours, but they're relatively inexpensive and straightforward to repair.

The 2015 Kia Soul models have a timing chain and an interference engine.

Visible Cracks and Wear

Regular visual inspections of the serpentine belt can reveal important information about its condition. If you notice cracks, fraying, or signs of wear on the belt's surface, it's a clear indication that it needs replacement.

Depending on your vehicle, and the other service you may or may not be having done at the time, the whole process of replacing the serpentine belt should take no more than two hours.

How do I know when my serpentine belt needs replacing? ›

Under ideal circumstances, a serpentine belt will last 60,000–100,000 miles. It's important to replace this belt as part of your vehicle's scheduled maintenance, even if it looks okay. You don't want this car part to break while you're on the road.

You can replace only the pulley, or you can buy a new tensioner with a new pulley attached, or you can buy a kit with a new belt, tensioner/pulley, and idler pulley if there is one, and do it all.

Only for a very short amount of time. Without the belt, neither the alternator nor the water pump will be driven. That means that the car battery will run down and the engine will overheat. Once either of those things happen, you'll have to stop driving and be stuck wherever you ended up.

If your serpentine belt breaks, all of these systems will shut down and your vehicle will overheat. An unfamiliar noise or screech from the engine compartment is just one indication that your belt could be frayed, split, or worn out.

Most vehicles nowadays usually have a belt routing sticker located somewhere in the engine compartment, making it even easier.

The tensioner pulley is responsible for keeping the belt tense while making sure it stays aligned the entire time you're driving. While the location of the tensioner pulley can vary depending on the vehicle, you can usually find it at the end of the tensioner, which is typically connected to the accessory drive belt.

To check the alignment of the belt, place a straight edge or laser alignment tool across the face of the pulleys, making sure it touches both pulleys. Then, move the straight edge or laser to the side of the belt and check for any gaps between the belt and the straight edge or laser.